Q7 MK 1 Discussion - 2012 TDI Warm Start Issue - Have been chasing a warm starting issue for a long time now. Manifests itself typically when the start/stop function decides to shut the car off. Upon restart, the car struggles to turn over exhibiting symptoms of a bad battery. I've replaced the battery even though the Originally Posted by RJC 1. I don't believe the 2.0 was available for MY 2017. Iirc, it was available late in the release cycle, I ordered in Nov. 2016 and it was not then, but I think it was by the time my vehicle arrived (March 2017) Reply Like. Q7 MKII Discussion - Very loud squeaking noise from the engine! - Today we noticed that there is a A4 (B8 Platform) Discussion - A4 B8 Intermittent Starting issue - I have a B8.5 A4 Quattro and have been experiencing an intermittent starting problem where the engine cranks but will not start unless you mash the throttle. No check engine lights, no active codes on the scanner. I notice it never happens when the car Q7 MKII Discussion - Intermittent “Electrical System Problem” message - Hey guys. So I picked up a Certified 2020 Audi Q7 premium plus 3.0T about a month ago and I’ve been getting the “electrical system malfunction” message on the dash intermittently. At one point it was that none of the cameras on the 360 camera Good day. Iam also having trouble with my 2007 audi q7 BUG engine. The engine will suddenly stop and cut off. Then will start again after a few mins. I have done scanning, and it showed P1040 005, itermittent circuit malfunction. All wiring harness were tested for continuity as well as injectors. All seems fine. Have anyone had this problem? ----- Address 03: ABS Brakes Labels:. 4L0-910-517-V1.clb Part No SW: 4L0 910 517 A HW: 4L0 614 517 A Component: ESP ALLRAD MK25E1 0130 Revision: 00H21001 Coding: 0038033 Shop #: WSC 31414 790 00001 VCID: 285FCD2C9B626A0AB5-807C 1 Fault Found: 01826 - Sensor for Steering Angle (G85); Supply Voltage Terminal 30 000 - - - Intermittent Freeze Frame I installed the repaired ABS electronics, and plugged the code reader in. It failed to connect so I cycled the ignition, unplugged it, and powered it off and on… still no connection. Ok, so I tried to start the car to see if the dash indicator showed the ABS problem anymore. The car turned over but would not start. pbabh7T.

audi q7 intermittent starting problem